Table of Contents
Advertisement
◆
Write Backed-up Parameters to the Drive
Show the frequency reference screen in advance.
Note:
Push and hold
to go back to the frequency reference screen from any screen.
Use these steps to write the parameters backed up in the keypad into a different drive.
Note:
• Make sure that you stop the drive before you restore the backed-up parameters.
• The drive does not accept Run commands while it is restoring parameters.
Push and hold
to go back to the frequency reference screen.
◆
Verify Keypad Parameters and Drive Parameters
Show the frequency reference screen in advance.
Note:
Push and hold
to go back to the frequency reference screen from any screen.
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Make sure that you stop the drive before you examine parameters.
• The drive does not accept Run commands while it is restoring parameters.
Push and hold
to go back to the frequency reference screen.
SIEPCYEUOQ2V01A Q2V Technical Manual
Figure 4.18 Writing backed up parameters
Figure 4.19 Verify Keypad Parameters and Drive Parameters
4.7 Keypad Operation
121
4
Advertisement
Table of Contents
Troubleshooting
