Omron Q2V Series Technical Manual page 280

8.5 Replace the Drive
• Do not tighten the terminal screws at an angle of 5 degrees or more. Failure to obey can cause damage to the
terminal screws.
• Put the bit all the way into the hex socket to tighten the hex socket cap screw.
• When you tighten slotted screws, hold the straight-edge screwdriver perpendicularly to the screw. Make sure
that you align the end of the straight-edge screwdriver with the screw groove.
• After connecting the wires to the terminal block, lightly pull on the wires to make sure that they do not come out
of the terminals.
• Do not let strain on the wiring cause damage. Use a strain relief near the wiring to release the tension. Refer to
Figure 8.19 for an example.
A - Cable clamp
Screw
Screw Shape
Size
M3
M4
*1
M5
M6
(WAF: 5 mm)
*1 When you wire drive models 2042, 2056, 4031, 4038, 4044, and 4060, select the correct tools for the wire gauge.
*2 Use 6.35 mm (0.25 in) bit socket holder.
*3 Use a torque wrench that can apply this torque measurement range.
■
Remove the Control Circuit Board
Remove the front cover and keypad from the drive.
280
Figure 8.17 Permitted Angle
Figure 8.18 Tightening Slotted Screws
Figure 8.19 Strain Relief Example
Table 8.13 Recommended Wiring Tools
Wire Gauge Adapter
- Bit
- Bit
≤ 25 mm 2
(AWG 10)
Bit
≥ 30 mm 2
(AWG 8)
- Bit
Bit Model Torque Driver Model
(Manufacturer) (Tightening Torque)
TSD-M 1,2NM
SF-BIT-SL 0,5X3,0-70
(0.3 - 1.2 N∙m
(PHOENIX CONTACT)
(2.7 - 10.6 in∙lb))
TSD-M 3NM
SF-BIT-SL 1,0X4,0-70
(1.2 - 3.0 N∙m
(PHOENIX CONTACT)
(10.6 - 26.6 in∙lb))
TSD-M 3NM
(1.2 - 3.0 N∙m
SF-BIT-SL 1,2X6,5-70
(10.6 - 26.6 in∙lb))
(PHOENIX CONTACT)
SF-BIT-HEX 5-50
(PHOENIX CONTACT)
Torque Wrench
(Tightening Torque)
-
-
-
4.1 - 4.5 N∙m
-
(36.3 - 39.8 in∙lb)
5 - 9 N∙m
-
(44.3 - 79.7 in∙lb)
SIEPCYEUOQ2V01A Q2V Technical Manual
*2 *3
*2 *3