Faults - Omron Q2V Series Technical Manual

7.4 Faults

7.4

Faults

This section gives information about the causes and possible solutions of faults. You must use the Fault Reset
operation to remove the fault before you can operate the drive. Use the information in this table to remove the
cause of the fault.
Code Name
bAT Keypad Battery Low Voltage
Note:
Use o4-24 [bAT Detection Selection] to enable/disable bAT detection.
Code Name
bCE Bluetooth Communication Fault
Note:
• The drive detects this error when you use the Bluetooth LCD keypad and operate the drive with a smartphone or tablet.
• Do a Fault Reset to clear the fault.
• Set the stopping method for this fault in o2-27 [BLE Disconn.Selection@BLE Ctrl].
Code Name
boL BrakingTransistor Overload Fault
Note:
Do a Fault Reset to clear the fault.
Code Name
bUS Option Communication Error
Note:
• The drive detects this error if the Run command or frequency reference is assigned to the option card.
• Do a Fault Reset to clear the fault.
• If the drive detects this error, the drive will operate the motor as specified by the stopping method set in F6-01 [Comm.Error Selection].
Code Name
CE Modbus Communication Error
222
Causes
The keypad battery voltage is low.
Causes
The smartphone or tablet with Q2dev Mobile
installed is too far from the keypad.
Radio waves from a different device are causing
interference with communications between the
smartphone or tablet and keypad.
Causes
The duty cycle of the braking transistor is high (the
regeneration power or repetition frequency is high).
You enabled the protective function for the braking
transistor when you have a regenerative converter.
The braking transistor in the drive is broken.
Causes
The drive did not receive a signal from the
controller.
The communications cable wiring is incorrect.
There is a short-circuit in the communications cable
or the communications cable is not connected.
Electrical interference caused a communication data
error.
The option is incorrectly installed to the drive.
The option is damaged.
Causes
The communications cable wiring is incorrect.
There is a short circuit in the communications cable
or the communications cable is not connected.
Possible Solutions
Replace the keypad battery.
Possible Solutions
Use the smartphone or tablet 10 m (32.8 ft) or nearer to the
keypad.
Note:
bCE can occur when the smartphone or tablet is 10 m (32.8 ft)
or nearer to the keypad depending on the specifications of the
smartphone or tablet.
Make sure that no device around the keypad uses the same radio
bandwidth (2400 MHz to 2480 MHz), and prevent radio
interference.
Possible Solutions
• Install a regenerative converter.
• Increase the deceleration time.
Set L8-55 = 0 [DB IGBT Protection = Disable].
Replace the drive.
Possible Solutions
Correct wiring errors.
• Repair short circuits and connect cables.
• Replace the defective communications cable.
• Examine the control circuit lines, main circuit lines, and
ground wiring, and decrease the effects of electrical
interference.
• Make sure that a magnetic contactor is not the source of the
electrical interference, then use a Surge Protective Device if
necessary.
• Use only the recommended cables or other shielded line.
Ground the shield on the controller side or the drive input
power side.
• Separate the communication wiring from drive power lines,
and install a noise filter to the input side of the power supply
for communication.
• Decrease the effects of electrical interference from the
controller.
Correctly install the option to the drive.
If the fault continues and the wiring is correct, replace the option.
Possible Solutions
Correct wiring errors.
• Repair short circuits and connect cables.
• Replace the defective communications cable.
SIEPCYEUOQ2V01A Q2V Technical Manual