Omron Q2V Series Technical Manual page 622

12.7 H: TERMINALS
If the drive does not receive data from the master during the time set in H5-09 [Mbus CE Detect Time], it will
detect a CE error.
0 : Disabled
Does not detect CE. The drive continues operation.
1 : Enabled
Detects CE. If the drive detects CE, it will operate as specified by the setting of H5-04 [Mbus Error Stop].
■
H5-06: Mbus Tx Wait Time
No.
Name
(Hex.)
H5-06 Mbus Tx Wait Time
(042A)
Note:
Restart the drive after changing the parameter setting.
■
H5-09: Mbus CE Detect Time
No.
Name
(Hex.)
H5-09 Mbus CE Detect Time
(0435)
■
H5-10: Mbus 0025H Unit Sel
No.
Name
(Hex.)
H5-10 Mbus 0025H Unit Sel
(0436)
0 : 0.1 V units
1 : 1 V units
■
H5-11: Mbus ENTER Command Mode
No.
Name
(Hex.)
H5-11 Mbus ENTER Command
Mode
(043C)
RUN
0 : Enter Required
Make all parameter changes then input the Enter command. You must use the Enter command to enable changes
to parameters.
1 : No Enter Required
It is not necessary to input the Enter command to change parameters.
622
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the time to wait to send a response message after the drive receives a command message
from the master.
Figure 12.99 Drive Transmit Wait Time
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the detection time for CE [Modbus Communication Error] issues when communication
stops.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the unit of measure used for the Modbus communications monitor register 0025H (output
voltage reference monitor).
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the function to make the Enter command necessary to change parameters through Modbus
communications.
Description
Description
Description
Description
SIEPCYEUOQ2V01A Q2V Technical Manual
Default
(Range)
5 ms
(0 - 65 ms)
Default
(Range)
2.0 s
(0.0 - 25.0 s)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)