Omron Q2V Series Technical Manual page 585

■
75: PID SS Cancel
Setting Value Function
75 PID SS Cancel
ON : No
Disables b5-17 [PID Accel/Decel Time].
OFF : Yes
Enables b5-17 [PID Accel/Decel Time].
Note:
"b5: PID CONTROL on page
Refer to
■
76: PID InLv Select
Setting Value Function
76 PID InLv Select
Note:
Refer to "b5: PID CONTROL on page
■
77: PID SP 1
Setting Value Function
77 PID SP 1
"b5-58 to b5-60: PID Setpoints 2 to 4 on page
Refer to
■
78: PID SP 1
Setting Value Function
78 PID SP 1
Refer to "b5-58 to b5-60: PID Setpoints 2 to 4 on page
■
7A: PID BiDir
Setting Value Function
7A PID BiDir
ON : Enabled
OFF : Disabled
■
7B: Fault Reset
Setting Value Function
7B Fault Reset
If the drive detects a fault, the drive will activate the fault relay output, turn off the output, and the motor will
coast to stop.
If the drive detects a fault for which you can set the stopping method, apply the appropriate Stopping Method.
Then push (RESET) on the keypad to turn the Run command OFF, or activate the fault reset terminal to reset
the fault.
Note:
The drive ignores the fault reset command when the Run command is active. Remove the Run command before trying to reset a fault.
SIEPCYEUOQ2V01A Q2V Technical Manual
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the PID soft starter function.
466" for more information.
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Sets the command to turn the terminal ON and OFF to switch the PID input level (polarity).
466" for more information.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Set this function and H1-xx = 78 [PID SP 2] together. Sets the function to switch the PID setpoint to b5-58 to b5-60 [PID
Setpoints 2 to 4].
479" for more information.
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
Set this function and H1-xx = 77 [PID SP 1] at the same time. Sets the function to switch the PID setpoint to b5-58 to b5-60
[PID Setpoints 2 to 4].
479" for more information.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets operation of the PID Bi-Directional function.
V/f OLV OLV/PM AOLV/PM EZOLV OLV/PM
Sets the command to reset the current fault when the Run command is inactive.
12.7 H: TERMINALS
Description
Description
Description
Description
Description
Description
12
585