Deselection Of A Fixed Cycle (G80); Program Example With A Tool Length Compensation And Fixed Cycles - Siemens SINUMERIK 808D Programming And Operating Manual

Deep hole tapping with chip breakage/removal
After positioning along the X and Y axes, there is a traversing movement at rapid traverse to point R. The machining is done
from point R onwards with a cutting depth Q (cutting depth per cutting feedrate). Finally, the tool is retracted by the distance
d. If a value not equal to 100% is specified in USER DATA, _ZSFI[2], it can be specified whether the retraction is overlaid or
not. The spindle stops as soon as point Z is reached; the direction of rotation is finally reversed and a retraction is executed.
The retraction path d is set in USER DATA, _ZSFR[1].
Note
If 0 is specified in _ZSFR[1], the default setting of 1 mm or 1 inch is effective for the retraction distance.
If 0 mm or 0 inch is to be specified, a value less than the travel triggering should be specified.
4.4.1.14

Deselection of a fixed cycle (G80)

Fixed cycles can be deselected with G80.
Format
G80;
Explanations
All modal cycles are deselected in ISO mode with G80 or with a G function of the 1st group (G00, G03,...).
4.4.1.15

Program example with a tool length compensation and fixed cycles

Program example (drilling cycle):
Offset value +200.0 is set in TO No. 11, +190.0 is set in TO No. 15 and +150.0 is set in tool offset No. 30.
146
Programming and Operating Manual (ISO Turning/Milling)
01/2017