Replace The Exhaust Plate Or The Exhaust Port Cover; Replace The Manifold Sub-Base, The Pneumatic Supply Plate Or The Right-Hand End Plate - Festo VTSA-44-MP Series Manual

5. Maintenance and conversion

5.3.3 Replace the exhaust plate or the exhaust port cover.

5.3.4 Replace the manifold sub-base, the pneumatic supply plate or the
right-hand end plate
5-14
If you wish to exhaust the air unducted via a silencer, use the
narrow metal silencer type U-½-B for exhaust plates (separate
exhaust ports 3 and 5) due to the limited space.
Proceed as follows:
1. Loosen the 4 retaining screws of the exhaust plate or the
6 retaining screws of the exhaust port cover and remove
them from the basis component.
2. Check the seal between the basis component and the
exhaust plate for damage. Replace the seal if it is
damaged.
3. Make sure that the seal is seated correctly in the groove
in the pneumatic supply plate.
4. Fasten the exhaust plate only with the original screws.
Tighten the screws in diagonally opposite sequence at
first slightly and then with 2.2 Nm
Information on mounting the manifold sub-base for the soft-
start valve can be found in the VABV-S6-1Q-... assembly
instructions.
Note
The number of manifold sub-bases with which your VTSA...
valve terminal can be fitted depends on the manifold sub-
bases and the electrical connection variant. Table Tab. 1/3
in Chapter 1 provides an overview.
(± 10 %) .
Festo P.BE-VTSA-44-EN en 1101f