Maintenance And Conversion - Festo VTSA-44-MP Series Manual

5. Maintenance and conversion

Contents of this chapter
Further information
Festo P.BE-VTSA-44-EN en 1101f
This chapter explains how to mount and remove the following
components for maintenance work and conversion:
– On valve positions: the mounting and removal of valves,
cover plates, pressure regulator plates, flow control
plates, vertical pressure shut-off plates and vertical
pressure supply plates.
– On the pneumatic supply plate: the mounting and removal
of the exhaust plate or the exhaust port cover.
– The mounting and removal of the manifold sub-bases, the
pneumatic supply plates and the right-hand end plate.
The following activities are also described:
– Adding of pressure zones
– Converting the valve terminal to internal or external pilot
air supply
Soft-start valve:
Information on mounting the soft-start valve with the corres-
ponding manifold sub-base can be found in the assembly
instructions provided with the product.
VTSA... valve terminal with CPX terminals:
Information on mounting /removing components and on the
electrical connections can be found in the CPX system
manual.
VTSA... valve terminal with FB 21 (type 03):
Information on mounting/removing components and on the
electrical connections can be found in the FB 21 electronics
manual.
VTSA... valve terminals with multi-pin:
Instructions on connecting the electric components can be
found in the package insert.
5-3