3. Installation
Contents of this chapter
Additional information
Festo P.BE-VTSA-44-EN en 1101f
This chapter describes the tubing and cabling of the VTSA...
valve terminal. This includes in particular the following:
–
General instructions on preparing the compressed air and
on connecting the tubing
–
Instructions on pilot control with an internal or external
pilot air supply
–
Instructions on operating the valve terminals with pressure
zones
–
Instructions on operating the valve terminal with reversible
2x3/2-way valves
–
Fitting the QS threaded connectors
–
Connecting the power supply
–
Earthing the valve terminal
–
Address assignment of the valves
Instructions on connecting the electrical components of the
VTSA... valve terminal with multi-pin node can be found in
the relevant information supplied with the product.
Requirements for observing the certified UL conditions if the
product is operated in the USA or Canada can be found in the
separate special UL-specific documentation.
Instructions on connecting the operating voltage for the
VTSA... valve terminal with CPX terminal can be found in
Chapter 3 of the CPX system manual.
Detailed instructions on how to connect CPX modules (fieldbus
nodes, I/O modules, etc.) can be found in the corresponding
CPX module descriptions. Detailed instructions for connecting
type 03 modules (fieldbus nodes, I/O modules) can be found
in the corresponding descriptions for the type 03 modules.
3-3