Festo VTSA-44-MP Series Manual page 75

2. Fitting
Variant
VTSA... valve terminal with multi-pin node
1
Tab. 2/3: Options for mounting the VTSA... valve terminal on a wall
Mounting
Dismounting
Festo P.BE-VTSA-44-EN en 1101f
Proceed as follows:
1. Make sure that the mounting surface is flat and that it
can support the VTSA... valve terminal (for weights,
see Appendix A, Tab. A/2).
Make sure there is sufficient space for connecting the power
supply cables and tubing.
2. Drill mounting holes in the mounting surface.
3. Fasten the valve terminal to the mounting surface with
correspondingly long screws (see Tab. 2/3).
Proceed as follows:
1. Secure a mounted hanging valve terminal VTSA... from
falling down before you loosen it from the mounting
surface.
2. Loosen the mounting screws (see Tab. 2/3).
3. Remove the valve terminal from the mounting surface.
Mounting option
– Multi-pin node:
Two M6 screws
– Right end plate:
1
Two M6 screws
1 Hole for M6 screw
2-13