Festo VTSA-44-MP Series Manual page 71

2. Fitting
1
H-rail
2
Clamping
component of the
H-rail clamping
unit
Fig. 2/2: Rear view: H-rail mounting, using the CPX terminal as an example
Dismounting
Festo P.BE-VTSA-44-EN en 1101f
1
2
Further instructions on mounting the VTSA... valve terminal
with CPX terminal onto an H-rail can be found in the CPX
system manual.
Proceed as follows:
1. Loosen the retaining screw of the H-rail clamping unit
(for position of the screws, see Tab. 2/2). Make sure that
the clamping component lies horizontally with respect to
the H-rail.
2. Swing the VTSA... valve terminal forwards from the H-rail
(see Fig. 2/3, arrow (B)).
3. Lift the valve terminal off the H-rail (see Fig. 2/3, arrow (A)).
2-9