Festo VTSA-44-MP Series Manual page 115

3. Installation
Cable
Pilot control (external pilot air supply):
2)
Pilot air
Complies with ISO
standard:
– Pilot air
Alternative, does not
comply with
3)
ISO standard:
– Ducted pilot exhaust of
4)
the pilot control
– Operating pressure
Air
Air or vacuum
1)
Depending on what you have ordered, the valve terminal will already be equipped with threaded
connectors.
2)
The external pilot air is supplied as standard via port (14).
3)
Requirement: the valve terminal must be fitted with Festo valves (except reversible 2x3/2-way
valves)
4)
Observe the correct position of the seals below the valves, see Chapter 5, Section 5.4.1;
also observe the note in the "common lines" section if you want to remove the pilot exhaust air
through ducts.
5)
If the VTSA... valve terminal is equipped with the end plate type VABE-...RZ-...and with reversible
2x3/2-way valves (ident. code P, Q and R), the operating pressure must also be supplied on
port 12. The valve terminal will then no longer be operated in conformity with ISO standards.
Tab. 3/4: Pneumatic ports of the VTSA... valve terminal
Festo P.BE-VTSA-44-EN en 1101f
Connections
(14)
(12)
5)
(2) or (4)
Pneumatic Connection
connection
(ISO 228)
G¼", ¼"NPT Fitting in the right end plate
G¼", ¼"NPT Fitting in the right end plate
Width 18 mm: Fitting in the manifold sub-base or
– Gx", x"NPT
in the 90° connection plate
Width 26 mm:
– G¼", ¼"NPT
Width 42 mm:
– GÅ", Å"NPT
Width 52 mm:
– G½", ½"NPT
1)
3-37