Festo VTSA-44-MP Series Manual page 206

B. Supplementary component summary
B.2 Separating the VTSA... valve terminal from the CPX terminal or FB 21
(type 03)
1
CPX terminal or
FB 21 (type 03)
2
Pneumatic
interface
3
Valve terminal
VTSA
Fig. B/1: Pneumatic interface (CPX)
Dismounting
B-14
The VTSA... valve terminal is connected to the CPX terminal
or the FB 21 (type 03) by means of a pneumatic interface
(see following diagram).
1 2
Proceed as follows:
1. Loosen the electrical and pneumatic connections, then
remove the VTSA valve terminal from its mounting surface
(see Chapter 5, "Dismantling the valve terminal").
2. Loosen the retaining screws between the pneumatic
interface and the manifold sub-base or pneumatic
supply plate of the VTSA... Valve terminal in the sequence
1 3 4 2 (see Fig. B/2).
3. Then loosen the retaining screws.
3
Festo P.BE-VTSA-44-EN en 1101f