B. Supplementary component summary
Festo P.BE-VTSA-44-EN en 1101f
4. Insert the retaining screws in the appropriate holes.
Tighten the screws in the sequence 1 3 4 2 (see
following diagram) at first slightly and then with 3.0 Nm.
1
4
Fig. B/4: Mounting the VTSA... valve terminal on the
pneumatic interface
5. Fasten the valve terminal onto the mounting surface
(see Chapter 2 in this manual or the CPX system manual).
6. Complete the electrical and pneumatic connections of
the VTSA... valve terminal with CPX terminal or FB 21
(type 03). Information on this can be found
–
in the pneumatics section in Chapter 3 of this
manual
–
in the section on electric components for VTSA valve
terminal with CPX terminal in the CPX system manual
–
in the section on electric components for VTSA valve
terminal with FB 21 in the FB 21 (type 03) electronics
description
2
3
B-17