Xerox 6060 Hardware Installation And Facts page 98

OPTIONS
2-66
. If you are connecting your workstation to an
NEU that has already been installed, plug
the other end of the cord into the first unused
IN jack on the NEU. Start with the IN jack
~
labeled
1
(Fig. 2-10).
• If
you are planning to connect your
workstation to an NEU but have not yet
installed the NEU, go to page 2-66, How to
Install an XC 22 Network Expansion
Unit, and complete those instructions.
Network
Extension Unit
OUT Jack
i l i i i i l i l i l l i .
Figure 2-10. Connecting the workstation to an NEU
18.
Return to Section 1, Installation, to finish
installing your system.
If you added an XC 22 board to a system that
was already set up:
Connect all plugs to the back of the~
processor.
Connect the power cord.
• Turn the system on.
OPTIONS