Completing The Diagnostic Test - Xerox 6060 Hardware Installation And Facts

DIAGNOSTICS
Completing the Diagnostic Test
4-12
1.
Wait for the message:
Tests completed. Number of test loops
=
1
Total errors during testing = 0
PRESS "ENTER" KEY TO CONTINUE-
2.
Press the RETURN key.
A TEST RESULTS summary screen (similar to
the one below) will be displayed.
TESTING RESULTS:
TEST#
ERRORS PASSES
TESTTinE
l---------l---------l------1---------------------
100 0 1 MAIN BOARD
300 0 256 KB MEMORY
400 0 83 KEY KEYBOARD
500
0
MONOCHROME VIDEO SYSTEM
600 0 t PARALLEL PORT(S)
700 0 1 SERIAL PORT(S) (USING 8250)
800 0 248TPI FLOPPY DISK DRIVE(S)
If a!l error occurs, run the test a second time. If
an error occurs again, write it down and contact
your service representative.
3.
Press the RETURN key to return to the
diagnostics screen. If you wish to run add-
itional tests, press the aepropriate test number
and repeat the steps outlined in this example.
4. Be sure the Diagnostic Disk is removed. If you
have a dual floppy system, insert the MS-DOS
Boot Disk. Press the RESET button on the
front of the processor.
Warning: The formatted disks used in this
Diagnostic exercise need to be reformatted
before they can be used again as data disks.
Failure to do so will result in data loss.
DIAGNOSTICS