Xerox 6060 Hardware Installation And Facts page 83

OPTIONS
OPTIONS
4.
If
your jumper block is inserted in the wrong
connectors, reposition it.
1
2
Figure 2-5. Remouing thejumper block
Carefully insert the tip of
a
small, flat-
bladed screwdriver under one end of the
jumper block and lift up gently until the
jumper block is partially free of the
connectors (Fig. 2-5).
Lift up. gently on the other end until it is
parallel with the first. Then grasp both ends
of the jumper block between thumb and
forefinger and pull straight up, taking care
not to bend the pins.
Figure 2-6. Inserting the jumper block
Reposition the jumper block over the correct
connectors. Align the pins on the jumper
block with the holes in the connectors (Fig. 2-
6).
2-51