Xerox 6060 Hardware Installation And Facts page 57

OPTIONS
OPTIONS
Set switches
1
through 4. To change a switch
setting, use the tip of a ball point pen or
small screwdriver to push the switch lever
into the other position. Do not change the
settings of switches 5 through 8.
Note: Of you're installing a new system and
have added other OP,tions, check the option
instructions to see if additional DIP switch
changes are required.
Front
Figure 2-6. Replace the bottom cover.
8.
Replace the bottom cover of the processor.
Position the front of the cover over the
RESET button CAREFULLY to avoid
damaging it. See Fig. 2-6.
Figure 2-7. Slide bottom cover into place.
Slide the cover toward the rear of the
processor until it is in place. Be sure the
edges of the cover fit over the processor
frame. See Fig. 2-7.
2-25