INSTALLATION
INSTALLATION
The steps below are for installing a partial-page (25
line) monochrome display.
If you have a color
display to install, turn to page 1-10. If you have a
full-page (66 line) display, turn to page 1-14.
1111111]
lllllllll
Figure 1-11. Connecting a monochrome display.
3.
Connect the monochrome display to the
processor.
- Place the display on top of the processor.
- Look at the end of the plug on the display
cable. Notice that the ring around the pins is
wider on one side. Turn the plug so that the
wider side is on the left, as shown in Fig 1-11.
- Insert the display plug (matching plug to
connector) into the
CRT
connector at the rear
of the processor.
- Secure the connection by tightening the two
screws on both sides of the plug. Take care
not to overtighten the screws.
- When finished, go to Step 11 on page 1-16.
1-9