Xerox 6060 Hardware Installation And Facts page 73

OPTIONS
Single Edge Connector
Single Edge Socket
Figure 2-4. Installing the coax option board.
OPTIONS
9.
Insert the edge connector into the socket and
press down firmly until the board "snaps" into
place.
10.
Secure the coax option board in the slot with
the screw removed earlier.
11.
Replace the top cover of the processor as
follows:
Lower the front of the cover into place. Press
in on the sides of the cover as you lower them
into place, making sure the cover edges fit
inside the processor frame. See Fig. 2-5.
With hands pressing firmly against the sides
of the cover, give one quick pull toward the
rear of the processor. Make sure the sides
stay inside the processor frame.
Tighten the two screws on the back to secure
the top cover.
2-41