Xerox 6060 Hardware Installation And Facts page 88

OPTIONS
2-56
Look at Fig. 2-12 to locate the BNC
connector on the XC 24 Network Access
Board.
• Connect the BNC T-adapter
to
this .___,,.-
connector.
•'
•'
•'
,:
:,
..
•'
..
,:
:•
•'
..
..
,•
,•
,:
Figure 2-12. Connect the BNC T-adapter to the XC 24
Network Access Board.
15.Connect a length of Thin-Cable Ethernet to one
end of the T-adapter, as shown in Fig. 2-13.
Locate the two small posts protruding from
the open ends of the T-adapter.
• See Fig. 2-13 to locate the slots on the
connector attached to the cable. Slide the
posts into these slots.
. Twist the collar of the cable connector until
the cable is locked in place.
OPTIONS