Checking The Operation Of The Fog Lights With The "Corner" Function (Static Cornering Light); Setting The Headlight Beam - Skoda Octavia III 2013 Service Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
The cornering light is now activated on the vehicle while it is
standing on its wheels.
Swivel the headlight horizontally
– Turn the steering wheel from the middle position to the right.
The light cone of the headlight must turn to the right (in accord‐
ance with the steering angle).
– Rotate the steering wheel again to the middle position.
The light cone must turn again to the initial position.
– Turn the steering wheel from the middle position to the left.
The light cone of the headlight must turn to the left (in accordance
with the steering angle).
– Rotate the steering wheel again to the middle position.
The light cone must turn again to the initial position.
Swivel the headlight vertically
– Slowly operate the accelerator pedal.
The light cone must swivel towards the bottom.
– Slowly release the accelerator pedal.
The light cone must turn upwards to the initial position.
This completes the test.
– Terminate the "presentation mode" and separate the diagnos‐
tic unit ⇒ Vehicle diagnostic tester.
6.16 Checking the operation of the fog lights
with the "Corner" function (static corner‐
ing light)
– Switch on ignition and low beam light.
– Turn the steering wheel from the middle position one turn to
the right.
The right fog light must switch on.
– Turn the steering wheel from the middle position one turn to
the left.
The left fog light must switch on.
6.17

Setting the headlight beam

• Basic setting for the inclination value adjustment: 1 %
Note
Use a headlight beam setting device for setting the headlight
beam. Nominal values and conditions
⇒ "6.13 Inspecting headlight beam setting and adjusting if nec‐
essary", page 138 .
142
6. Electrical System