Special Features Of The System Of Measurement - Festo CPX Series Manual

6. Parametrisation

6.1.2 Special features of the system of measurement

6−6
The following special rules apply to accessing the system of
measurement. For detailed information on the system of
measurement, see section B.1:
The system of measurement cannot be switched over at
will. To change the system of measurement, the axis data
must be reset.
After defining the system of measurement (metric / im
perial), the cylinder type must be transmitted. This de
fines the movement type translatorily / rotatorily.
Only when the system of measurement has been defined,
can PNUs be accessed that are larger than PNU 300 (ex
ceptions: PNU 1100, 1190).
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH