A.2.2 Step−For−Step Instructions For Basic Parametrising - Festo CPX Series Manual

A. Notes on commissioning and service
A.2.2 Step−for−step instructions for basic parametrising
Step 1:
Switch on con
troller. Status C00
is now active.
Step 2:
Select commis
sioning mode
B7
CCON OPM2
Set 1
point
SCON OPM2
Set 1
point
A−12
1. Check status (read PNU 1192:02 −> setpoint = 0).
2. Recommendation: Write device names (PNU 121).
Basically the default value CMAX1" can be used, but an
individual name is recommendable in case you also in
tend to access the controller with FCT.
3. Check version number of the firmware (read PNU 101).
Prior to parametrising you should ensure that the CMAX
is really compatible with the following project data.
4. Activate Commissioning" mode in the CCON, wait for
acknowledgement in the SCON.
STOP and ENABLE must not be set.
B6 B5 B4
OPM1 LOCK
0 x 0
OPM1 FCT_MMI 24VL
0 x x
If the parameters are to transmitted via the cyclical I/O data
of the PLC, Parametrising" mode must be selected.
OPM2 OPM1
1 0
1 1
B3 B2
RESET BRAKE
x x
FAULT WARN
0 0
Operating Transmit parameters via
mode
Commissioning CI/DIAG or module para
meters, e.g. DPV1
Parametrisa Usage of cyclical I/O data
tion bytes 2..8
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
B1 B0
STOP ENABLE
0 0
OPEN ENABLED
0 0