Configuration Of The System Via Yjkp Software - Festo YJKP Quick Start Manual

Software
5.3

Configuration of the system via YJKP software

Open a browser and start the WebVisu of the YJKP.
<IP of the CECC-X>:8080/servo_press_kit.htm
If you switch to Diagnosis -> Interface diagnosis, you should see a screen similar to this one.
Important at this step: X3.5 and X17.4.2 should be high, otherwise it will be not possible to do any move-
ment.
In this case the manual operating mode is switched on, because we will need to do a homing later
(X20.2.1 – Homing requirement is high).
To activate the commissioning tab, please log in.
Page 22 of 29 Application Note – YJKP - Quick Start Guide EVO3 – 1.20