Project Data - Festo CPX Series Manual

5. Parameter

5.4.6 Project data

Project zero point
PNU PNU: 500
Values Unit: Position (index = 1)
Linear drive
Dimension Default Minimum
SI 0.01 mm
Imperial 0.001 in
Reference point for position values in the application. See section B.2.
o The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
ý After writing, controller recalculation is carried out.
5−52
General description of the dimensional reference system, see
section B.2.
Index: 1
Maximum Dimension Default Minimum Maximum
−1.000.000 1.000.000 0,1 °
0
0 −393.701 393.701
Max index: 1 Class: Var
Semi−rotary drive
0,1 °
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Data type: int32
0 −100.000 100.000
0 −100.000 100.000