System Data - Festo CPX Series Manual

5. Parameter

5.4.16 System data

Actual hardware configuration
PNU PNU: 1190
Values see description of the respective index.
Default: 0
Hardware configuration found after switching on (actual configuration).
Value 0 means that the parameter could not be recognized automatically.
The actual configuration contains the same parameters as the setpoint configuration (PNU 1100 to
1129). Units and values are identical. For comparison, the PNUs are listed here as well.
Index Value
1 Cylinder type
2 Cylinder effective length
3 Cylinder diameter
4 Piston rod diameter
5 Cylinder nominal length
10 Sensor type
11 Sensor length
12 Sensor serial number
13 Sensor resolution
14 Sampling time
15 Sensor additional information
16 Firmware version
20 Valve 1 type
21 Valve 1 serial number
22 Valve 1 firmware version
23 Valve 1 hardware version
30 Valve 2 type
31 Valve 2 serial number
32 Valve 2 firmware version
33 Valve 2 hardware version
ý The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Index: 1 Max index: 33
Minimum: −
Value of setpoint
configuration
PNU 1100
PNU 1101
PNU 1102
PNU 1103
PNU 1101
PNU 1110
PNU 1111
PNU 1112
PNU 1120
PNU 1121
PNU 1125
PNU 1126
Class: Struct Data type: int32
Maximum: −
Unit
Length (index 2)
Diameter (index 11)
Diameter (index 11)
Length (index 2)
Length (index 2)
1 m
1 sec
5−93