C.2.2 Parametrisation (Rsnetworx Example) - Festo CPX Series Manual

C. Configuration with CPX node

C.2.2 Parametrisation (RSNetworx example)

1
Buttons for uploading and
downloading the parameters
Fig. C/6: Parametrisation with modular EDS
C−18
When modular EDS is used, you can set the parameters by
module with RSNetWorx.
Note the general instructions on CPX parametrising in
section 1.3.
Make sure that parameters cannot be unintentionally over
written. If necessary, carry out an upload.
The following diagram shows the Module Configuration"
register of the CPX terminal. Double clicking on the module in
the configuration table brings you to the window for setting
the parameters.
1
2
3
System parameters and data
Module parameters
Festo P.BE−CPX−CMA X−CONTROL−EN en 0908NH
2
3