System Control - Festo SPC200 Series Quick Reference

Hide thumbs Also See for SPC200 Series:

Available languages

SPC200-...

Recommendation (for first commissioning):

Determine the test program entered as start program A.

Deactivate start program B (Startpr. B=***).

Set the operating mode Start/Stop. Programs can then be

controlled independently of a higher-order PLC/IPC e.g. with

the control panel (easier test possibilities).

4. Load the settings into the SPC200 with "Download."

5. Accept the settings with "OK". Save any modifications to the

project (with active project window, command [File] [Save]).

Step 9: Test the program in Debug mode or in continuous

run

Requirements:

– the program must be in program memory

– the axis and application parameters must be set and the

project loaded into the SPC200

– the operating mode Start/Stop and the start program must

be set

– There must be a 1-signal at ENABLE and STOP.

Test the program in Debug mode

•

Test the program with the Debug mode in WinPISA (com-

mand [Online] [Control axes] or with the control panel (com-

mand SINGLE STEP, TEST/DIAG).

Start the program

•

Start the program with a rising edge at the START input or

with the control panel (command START SYSTEM, menu

SYSTEM CONTROL).

9904a