Access To Control Terminals; Electrical Installation, Control Terminals - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide

Access to Control Terminals

"
All terminals to the control cables are located
underneath the terminal cover on the front of the
frequency converter. Remove the terminal cover
by means of a screwdriver (see illustration).

Electrical Installation, Control Terminals

"
Mount terminals from the accessory bag
1.
to the front of the FC 300.
Connect terminals 18, 27, and 37 to +24 V
2.
(terminal 12/13) with the control cable.
Default settings:
18 = start
27 = coast inverse
37 = safe stop inverse
NB!:
To mount the cable to the terminal:
Strip isolation of 9-10 mm
1.
Insert a screw driver in the square hole.
2.
Insert the cable in the adjacent circular hole.
3.
4. Remove the screw driver. The cable is now
mounted to the terminal.
92
How to Install
MG.33.B4.02 - VLT is a registered Danfoss trademark