Additional Text - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide
If bit 13 is true, the parameter cannot be changed while running.
If bit 15 is true, the parameter is depending on the power unit.

Additional Text

"
With this feature it is possible to read additional
text if bit 10, Additional text available, is
true in Basic characteristics.
To read out additional text, the parameter command
(PKE) must be set to F hex, see Databytes.
The index-field is used for pointing out which
element to read. Valid indexes are in the range
of 1 through 254. The index must be calculated
after the following equation:
Index = Parameter value + 1 (see table below).
Example:
In this example, the Master reads additional text in par. 0-01, Language. The telegram is set up to read
data value [0] (English). You must send the following telegram to the frequency converter:
STX LGE
02 0E
STX = 02 Start byte
LGE = 0E Length of the remaining telegram
ADR = Send the VLT frequency converter on Address 1, Danfoss format
PKE = F001; F in the PKE field indicates a Read text and 01 indicates par. 0-01, Language.
IND = 0001; 1 indicates that text to parameter value [0] is required
The response from the frequency converter is:
STX LGE
02 11
PKE = F001; F is the response for Text transfer and 01 indicates par. 0-01, Language.
IND = 0001; 1 indicates that index [1] is sent
PVA = 45 4E 47 4C 49 53 48
E N G L I S H
The parameter value channel is now set up to a visible string, which returns an ASCII
character for each letter in the index name.
default setting ( )
*
260
How to Programme
ADR PKE IND
01 F0 01 00 01
ADR PKE
01 F0 01 00 01
display text [ ] value for use in communication via serial communication port
MG.33.B4.02 - VLT is a registered Danfoss trademark
Value
0
1
2
3
4
5
PWE PWE
HIGH
00 00 00 00
IND PVA
454E 474C 4953 48
Index Text
1 English
2 Deutsch
3 Français
4 Dansk
5 Espanol
6 Italiano
PCD1 PCD2
LOW
XX XX XX XX
PCD1 PCD2
XX XX XX XX
BCC
XX
BCC
XX