Quick Transfer Of Parameter Settings - Danfoss VLT AutomationDrive FC 300 Design Manual

FC 300 Design Guide
[Auto On] enables the frequency converter is to be controlled via the control terminals and/or serial
communication. When a start signal is applied on the control terminals and/or the bus, the frequency
converter will start. The key can be selected as Enable [1] or Disable [0] via par. 0-42 [Auto on] key on LCP.
NB!:
An active HAND-OFF-AUTO signal via the digital inputs has higher priority than
the control keys [Hand on] – [Auto on].
[Reset] is used for resetting the frequency converter after an alarm (trip). It can be selected
as Enable [1] or Disable [0] via par. 0-43 Reset Keys on LCP.
The parameter shortcut
The parameter shortcut allows direct access to any parameter.

Quick Transfer of Parameter Settings

"
Once the set-up of a drive is complete, we
recommend that you store the data in the LCP or
on a PC via MCT 10 Set-up Software Tool.
Data storage in LCP:
Go to par. 0-50 LCP Copy
1.
Press the [OK] key
2.
Select "All to LCP"
3.
4. Press the [OK] key
All parameter settings are now stored in the LCP indicated by the progress bar.
When 100% is reached, press [OK].
NB!:
Stop the motor before performing this operation.
You can now connect the LCP to another frequency converter and copy the parameter
settings to this frequency converter as well.
122
How to Programme
can be carried out by holding down the [Main Menu] key for 3 seconds.
MG.33.B4.02 - VLT is a registered Danfoss trademark