Danfoss VLT AutomationDrive FC 300 Design Manual page 123
Hide thumbs
Also See for VLT AutomationDrive FC 300:
- Design manual (296 pages) ,
- Programming manual (277 pages) ,
- Operating instructions manual (169 pages)
Table of Contents
Advertisement
FC 300 Design Guide
Data transfer from LCP to drive:
Go to par. 0-50 LCP Copy
1.
Press the [OK] key
2.
3.
Select "All from LCP"
Press the [OK] key
4.
The parameter settings stored in the LCP are now transferred to the drive indicated by
the progress bar. When 100% is reached, press [OK].
NB!:
Stop the motor before performing this operation.
How to Programme
MG.33.B4.02 - VLT is a registered Danfoss trademark
123
Advertisement
Table of Contents
Need help?
Do you have a question about the VLT AutomationDrive FC 300 and is the answer not in the manual?
Questions and answers