Information On The Web-Based Management System - WAGO 750-341 Manual

4.
5. A list of all protocols supported by the coupler is displayed. The BootP
6. You can disable other protocols you do not need in a similar way, or enable
7. To store the protocol selection, click the SUBMIT button and then perform
8. The protocol settings are now stored EEPROM and the coupler is ready to
3.1.6.7

Information on the web-based management system

In addition to the web pages already described in section 3, the following
HTML pages are stored in your coupler and provide information and
configuration options. After opening the default page of your coupler, you can
access these pages via the hyperlinks in the left navigation bar of the browser
window.
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
Click the "Port" hyperlink on the left navigation bar.
protocol is activated by default. To disable the protocol, click on the check
box after BootP to remove the check mark.
protocols you wish to use, e. g. Ethernet IP, Modbus TCP or Modbus UDP.
It is possible to enable several protocols at the same time, since each
protocol uses a different port.
a hardware reset. To do this, either switch off the power supply of the
coupler for ca. 2 seconds or press down the operating mode switch.
operate.
If you activated e.g. the MODBUS TCP protocol, you now can select and
implement various MODBUS functions with a MODBUS Mastertool, as for
example the inquiry of the clamp configuration via register 0x2030.
Fieldbus Coupler 750-341
Starting up ETHERNET TCP/IP fieldbus nodes
• 75