Ptz Linkage - EverFocus VANGUARD 16x8H Plus User Manual

5.3.5.5 PTZ Linkage

You can associate an alarm trigger (motion or I/O) with a specific camera and then activate a
PTZ camera to go to a preset position when the alarm is triggered.
Channel: Select a channel from the drop-down list.
Switch: Switch the button to the right to enable the PTZ Linkage function.
Alarm Type:
- Motion: Check the box to trigger the PTZ Linkage function when a motion event occurs.
- IO: Check the box to trigger the PTZ Linkage function when an IO event occurs.
- PIR: Check the box to trigger the PTZ Linkage function when a PIR event occurs.
PTZ1-4: Associates the PTZ camera with preset points. Please set up the preset points of your
PTZ (analog or IP) cameras in advance (please refer to 5.2.3 PTZ Setting Panel). After setting up
the preset points, check the PTZ box here and then select a channel and preset number.
For example, if the PTZ camera is assigned to CH2, select CH2 from the PTZ channel dropdown
list and then select a desired preset point. When an even is triggered on the selected channel,
the configured PTZ camera will turn to the preset point.
Click Save to save the settings or Refresh to refresh the page.
Click the Copy button to display the channel options. Select the channels and then click the
Copy button to copy the same configurations from this channel to the selected channels.
H.265 VANGUARD 16x8H Plus
202