VANGUARD 16x8 / VANGUARD 8x4 / VANGUARD 4x2
4.1.1.5.3 PTZ Linkage
You can associate an alarm trigger (motion or I/O) with a specific camera and then activate a
PTZ camera to go to a preset position when the alarm is triggered.
Channel: Select a channel to be associated with the alarm.
Switch: Enable or disable the function.
Alarm Type: Select the desired alarm(s).
PTZ: Associates the PTZ camera with preset points. Please set up the preset points of your
PTZ (analog or IP) cameras in advance. After setting up the preset points, the preset number
will be listed on the drop-down list. To activate the function, check the PTZ checkbox first. If
the PTZ camera is assigned to CH2, select CH2 from the channel dropdown list and then
select a desired preset point. When an even is triggered, the configured PTZ camera will turn
to the preset point.
Click Default to return to factory default value, Save to save the settings, or Cancel to cancel
and leave the page.
56