Pir Alarm - EverFocus VANGUARD 16x8H Plus User Manual

H.265 VANGUARD 16x8H Plus

5.3.5.2 PIR Alarm

After configuring the PIR Detection settings, you can further configure the PIR Alarm settings.
To configure the PIR Detection setting, please refer to 5.3.3.6 PIR).
Channel: Select a channel from the drop-down list.
Buzzer: Select a time for DVR buzzer to sound when an event is triggered. Select Disable to
disable the function.
Alarm Output: Select an alarm output time (duration) when events occur. When an event is
triggered, the alarm will last based on the setup latch time.
Post Recording: Select a post recording time when an event is triggered.
Send Email: Switch the button to the right to enable the Email alert function. When an event is
triggered, the DVR will send an email alert with a snapshot to the pre-configured Email receiver.
Note that for this function to work, you have to set up the Email function in advance (refer to
5.3.6.3 Email).
Show Message: Switch the button to the right to enable displaying an alarm message on the
live channel when an event is triggered.
Full Screen: Switch the button to the right to enable the full screen function. If this function is
enabled and an event is triggered, the triggered channel will be displayed in full screen.
FTP Picture Upload: When an event is triggered, the DVR will upload alarm images to FTP
server. Note that for this function to work, you have to set up FTP configurations in advance.
You can also configure the snapshot image resolution and quality, please refer to 4.3.6.4.1 FTP.
196