Exception Alarm - EverFocus VANGUARD 16x8H Plus User Manual

5.3.5.6 Exception Alarm

You can configure the system alarm settings on this page.
Event Type: Select an event type.
•
No Space on Disk: When an HDD is full.
•
Disk Error: When the HDD is not detected properly.
•
Video Loss: When a camera is not connected properly.
Enable: Switch the button to the right to enable this function.
Buzzer: Select a time for DVR buzzer to sound when an alarm is triggered. Select Disable to
disable the function.
Show Message: Switch the button to the right to enable displaying system alarm message on
the live channel when an alarm is triggered.
Send Email: Switch the button to the right to enable the Email alert function. When an alarm is
triggered, the DVR will send an email alert with a snapshot to the pre-configured Email receiver.
Note that for this function to work, you have to set up the Email function in advance (refer to
5.3.6.3 Email).
Alarm Output: Select an alarm output time (duration) when events occur. When an event is
triggered, the alarm will last based on the setup latch time.
Trigger Alarm Out: Select an external alarm output device connected to the DVR, IPCam or
both.
Click Save to save the settings or Refresh to refresh the page.
Click the Copy button to display the channel options. Select the channels and then click the
Copy button to copy the same configurations from this channel to the selected channels.
H.265 VANGUARD 16x8H Plus
203