Configuring Pedestrian Detection Area - EverFocus VANGUARD 16x8H Plus User Manual

4.1.8.4.1 Configuring Pedestrian Detection Area

Click the Setup button
1. Select 1 from the Rule Number drop-down list to configure the area.
2. Select Enable from the Rule Switch drop-down list to enable this rule.
3. Define a type for this rule. Only Normal type is available.
4. To draw an area:
a. Use your mouse to click 4 points to draw a rectangle shape. The shape should be
convex. Concave shape is not allowed.
b. If you want to move the area to other position or re-size the area, select the area by
checking the red box on the upper-left corner of the area, the borders of the area will
change to red color. Drag and drop the area to a desired position. Drag the red dots
at the edge of the area can re-size the area.
1
c. Click the Save button to save the settings.
d. You can click the Remove All button to remove all the areas. To remove a certain
area, select the area by checking the red box on the upper-left corner of the area,
and then click the Remove button.
Note: The configured areas should not be too narrow or small in order to enhance
the detection rate. The whole target object (people) should be inside the area.
5. To return to the Pedestrian Detection setup page, right-click the mouse.
to enter the Area setup page.
54
H.265 VANGUARD 16x8H Plus