Ptz - EverFocus VANGUARD 16x8H Plus User Manual

5.3.3.4 PTZ

Please connect the PTZ cameras to the DVR and then configure the below PTZ settings. After
configuring the PTZ settings, you can start using the PTZ Control panel to control the connected
PTZ camera. Please refer to 5.2.3 PTZ Setting Panel.
Channel: Select a channel.
Protocol: Select a communication protocol between the PTZ camera and DVR. If your camera
supports the UTC function, select UTC1 or UTC2. For more details on UTC function, please refer
to 3.4.2.3 UTC Control.
Note: For EverFocus' PTZ cameras, only the UTC-supported PTZ cameras support the UTC
function.
Baudrate: This field is to set the speed at which is used to transmit instruction or information from
the DVR to the PTZ camera.
Data Bit / Stop Bit: The information between the DVR and PTZ camera is sent in individual packages.
The Data Bit indicates the number of bits sent, while the End Bit indicates the end of the package
and the beginning of the next (information) package.
Parity: For error check. Refer to the documentation of your PTZ camera to configure this setting
Address: Input the ID address of the PTZ camera. Note this address should match the one set up on
the PTZ camera.
Click Save to save the settings or Refresh to refresh the page.
Click the Copy button to display the channel options. Select the channels and then click the
Copy button to copy the same configurations from this channel to the selected channels.
H.265 VANGUARD 16x8H Plus
164