Ptz Linkage - EverFocus H.265 VANGUARD II Series User Manual

4.3.4

PTZ Linkage

You can associate an alarm trigger (motion or I/O) with a specific camera and then activate a
PTZ camera to go to a preset position when the alarm is triggered.
Channel: Displays the channel number.
Switch: Check the box to enable the PTZ Linkage function.
Motion: Check the box to trigger the PTZ Linkage function when a motion event occurs.
IO: Check the box to trigger the PTZ Linkage function when an IO event occurs.
PTZ1-4: Associates the PTZ camera with preset points. Please set up the preset points of your
PTZ (analog or IP) cameras in advance (please refer to 3.5.2.2 Preset Setting). After setting up
the preset points, click
camera is assigned to CH2, select CH2 from the channel dropdown list and then select a
desired preset point. When an even is triggered, the configured PTZ camera will turn to the
preset point.
Copy: You can apply the same configurations from one channel to other channels. Select a
channel from the Source Channel drop-down list and then select the parameters you would
like to apply to other channels. Select the desired channels from the Target Channel field and
then click the Copy button.
Default: Click to apply the default setting.
Apply: Click to save the settings.
to configure a PTZ camera and the preset number. If the PTZ
73
H.265 VANGUARD II Series