Pir - EverFocus VANGUARD 16x8H Plus User Manual

4.1.7

PIR

This function is only available when the supported analog/IP cameras with PIR function are
connected. For the supported cameras, please contact EverFocus (ts@everfocus.com.tw).
When the camera detects an object move in or out of the PIR sensor range, the DVR will start
recording or send alert notifications.
To configure the PIR Detection settings:
1. Click to bring-up the PIR Area Setup page.
a. Select a channel from the Channel drop-down list.
b. Select Enable from the Switch drop-down list to enable PIR detection function.
c. To set up PIR detection sensitivity level, select a value from the Sensitivity drop-down
list. The higher the value the higher the sensitivity.
d. Click Select All to set the whole screen of the camera as PIR detection area. Click
Delete All to clear the whole area. You can also set up an area by drawing a polygon
shape (at least five sides) on the image. You can also drag the area and drop it to the
H.265 VANGUARD 16x8H Plus
45