Pir - EverFocus VANGUARD 16x8H Plus User Manual

5.3.3.6 PIR

This function is only available when the supported analog/IP cameras with PIR function are
connected. For the supported cameras, please contact EverFocus (ts@everfocus.com.tw).
When the camera detects an object move in or out of the PIR sensor range, the DVR will start
recording or send alert notifications.
To configure the PIR Detection settings:
1. Select a channel from the Channel drop-down list.
2. Switch the Enable button to the right to enable the PIR detection function.
3. Select a PIR detection sensitivity level from the Sensitivity drop-down list. The higher the
value the higher the sensitivity.
4. To draw a detection area:
a. Draw a polygon shape (at least five sides) on the image.
b. If you want to move the area to other position or re-size the area, select the area by
checking the red box on the upper-left corner of the area, the borders of the area will
change to red color. Drag and drop the area to a desired position. Drag the red dots at
the edge of the area can re-size the area.
5. Click the Save button to save the settings.
6. To further set up the PIR event notifications, enter the PIR alarm setup page (please refer to
5.4.3.2 PIR).
7. To further set up the PIR recording function, enter the Record Schedule setup page (please
refer to 4.3.4.2.2 Record Schedule).
Click Save to save the settings or Refresh to refresh the page.
Click the Copy button to display the channel options. Select the channels and then click the
Copy button to copy the same configurations from this channel to the selected channels.
H.265 VANGUARD 16x8H Plus
166