EverFocus VANGUARD 16x8H Plus User Manual page 180

7. To draw an area:
a. Use your mouse to click 4 points to draw a rectangle shape. The shape should be
convex. Concave shape is not allowed.
b. If you want to move the area to other position or re-size the area, select the area by
checking the red box on the upper-left corner of the area, the borders of the area will
change to red color. Drag and drop the area to a desired position. Drag the red dots at
the edge of the area can re-size the area.
c. Click the Save button to save the settings.
d. You can follow the steps above to configure more areas. Up to 4 areas can be
configured.
e. You can click the Clear button to remove all the areas. To remove a certain area, select
the area by checking the red box on the upper-left corner of the area, and then click
the Delete button.
Note: The configured areas should not be too narrow or small in order to enhance the
detection rate.
8. You can click the Copy button to display the channel options. Select the channels and then
click the Copy button to copy the same configurations from this channel to the selected
channels.
9. To further set up the Intelligent alarm function, enter the alarm setup page (please refer to
5.3.5.4 Intelligent Alarm).
10. To activate the intelligent recording function, you need to configure the record schedule
(please refer to 5.3.3.8.9 Record Schedule).
1
H.265 VANGUARD 16x8H Plus
169