Epson RC700 Manual page 78

2. Installation
Board Installation
 Make sure that the power is turned OFF before installing/removing any boards or
connecting/disconnecting any cables. Working with the power ON is extremely
hazardous and may result in electrical shock and/or malfunction of equipment.
WARNING
1.
2.
3.
4.
5.
6.
68
Configure the board address dip switch (JP1) on PROFIBUS-DP master board.
You can install one Fieldbus master board to the PC with the EPSON RC+ 7.0
installed.
The board number should be "1".
Refer to the following table for JP1 configuration.
Switch
Board No.
1
Install the PROFIBUS-DP master board to the PCI bus of the PC with the EPSON
RC+ 7.0 installed. Installation method of the PROFIBUS-DP board to the PCI bus
and how to open the cover differ depending on the type of computers. Refer to the
manuals of each computer on how to install the board to the PCI bus.
Connect the PROFIBUS-DP master board with the PROFIBUS-DP netword.
Start up the PC.
Open the <applicomIO Console> installation folder and start the <applicomIO
Console> application.
Following is specified for <applicomIO Console> installation folder as default.
C:\Program Files(x86)\BoadCommunications\applicomIO\4.1
The [Add New Board] dialog box appears. Add the PROFIBUS-DP master board.
Click <Add Board>.
C0 C1
OFF OFF
RC700 / RC90 Option Fieldbus I/O Rev.12
C2
OFF