Epson RC700 Manual page 162

2. Installation
(5) Set each item to the specific value to connect the CC-Link network.
(6) Click <Close>.
Editing of Input/Outout size
(1) Select [Setup]-[System Configuration] and display the [System Configuration]
(2) Select [Inputs / Outputs]-[Fieldbus Slave]-[General].
(3) Change the settings of [Input Byte] and [Output Byte].
(4) Click <Apply>.
(5) Click <Close> and the following dialog box appears.
152
For information about the setting values, contact your network administrator.
You can change the input/output size of the CC-Link slave module if necessary.
dialog box.
In this example, both of them are changed to 20 Bytes.
T3 series Manipulator (Controller) automatically starts rebooting.
RC700 / RC90 Option Fieldbus I/O Rev.12