Epson RC700 Manual page 133

Robot controller fieldbus i/o
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

14. Select [Fieldbus Master]-[Slave].
15. Confirm that the following information the master controls are displayed.
"Encapsulation Inactivity Timeout"
Fieldbus EtherNet/IP master board is not supported "Encapsulation Inactivity Timeout"
which is added by EtherNet/IP standard update.
If connecting the EtherNet/IP slave device that supports "Encapsulation Inactivity
Timeout", connection will be disconnected due to inconsistency with standard update on
the above.
You need to change the set value of "Encapsulation Inactivity Timeout" on the Fieldbus
EtherNet/IP master board side.
RC700 / RC90 Option Fieldbus I/O Rev.12
(14)
ID
: Fieldbus station ID of slave
Input Bytes
: Number of inputs per slave (Bytes)
Output Bytes : Number of outputs per slave (Bytes)
Spel Inputs
: Number of inputs per slave (Bits)
Spel Outputs : Number of outputs per slave (Bits)
(15)
(15)
2. Installation
123

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc90

Table of Contents