2. Installation
7. The [Add New Board] dialog box appears.
8.
9.
32
Confirm that "PCU-DVNIO" is displayed in [Board to Add]-[Board Type]
and click <OK>.
If the board cannot be detected, the following dialog appears. Make sure that the
board is correctly inserted.
When you finish adding the DeviceNet master board to the applicomIO Console
application, reboot the PC.
8-1
Shutdown the applicomIO Console application.
When the applicomIO Console application shuts down, the message
below appears. Click <Yes>.
8-2
The next message dialog follows. Click <OK>.
8-3
Reboot the Windows.
After the PC is rebooted, refer to the next section Master Mode and continue the step.
RC700 / RC90 Option Fieldbus I/O Rev.12