Epson RC700 Manual page 177

Configure switch configuration
The PROFINET module requires no configurations.
All the PROFINET communication configurations are set by the development software
(EPSON RC+ 7.0).
Wiring
PROFINET connector is RJ45 connector. Use 100BASE-TX (STP type) cable.
 Be sure to use cables and connectors complying with the industrial standards or
noise resistant Ethernet cable (STP cable). If you use an office use product or
UTP cable, it may cause communication errors and may not offer the proper
CAUTION
performance.
Module Installation
 Make sure that the power is turned OFF before installing/removing any modules
or connecting/disconnecting any cables.
extremely hazardous and may result in electrical shock and/or malfunction of
WARNING
equipment.
Install the module to the dedicated slot on the T3 series Manipulator.
Reference manual:
RC700 / RC90 Option Fieldbus I/O Rev.12
T3 series Manipulator Setup&Operation 17. Fieldbus I/O
Working with the power ON is
2. Installation
167