Epson RC700 Manual page 152

2. Installation
5.
6.
Editing of input / output size
You can change the input/output size of the CC-Link slave board if necessary.
1.
2.
3.
4.
5.
142
Make sure that the following are displayed.
Fieldbus Type : CC-Link
Input Bytes : 32 (default setting)
Output Bytes : 32 (default setting)
Click <Close>.
Select [Setup]-[System Configuration] and display the [System Configuration] dialog
box.
Select [Inputs / Outputs]-[Fieldbus Slave]-[General].
Change the settings of [Input Byte] and [Output Byte].
In this example, both of them are changed to 20 Bytes.
Click <Apply>.
Click <Close> and the following dialog box appears.
The Robot Controller automatically starts rebooting.
RC700 / RC90 Option Fieldbus I/O Rev.12